Rising Phoenix – proiect STL 3D

3D MODEL DESCRIPTION

Rising from the ashes is too boring, have you tried reviving from the steam?
This STL file is recommended for FDM Printers!
3D Printing Time Based on Ender 3: 03 Days 17 Hours 21 Minutes (will vary accord to you printer model)
Approximately Height: 26 cm

3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)

Line Width/ Nozzle: 0.4 mm
First Layer Line Width: 0.48 mm / 120%
Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) | 20 mm/s (First Layer) / 500 mm/s (All the other layers on Bambu Lab)
Recommended Initial Layer Height: 0.16 mm
Recommended Layer Height: 0.16 mm
Recommended Perimeters/ Walls: 3.
Recommended Infill (%): 10% (Gyroid)
Needs Support: Yes. (Use Tree/ Organic Supports)
Build Plate Adhesion: Skirt.

3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE) – FOR THE WATER TANK

Line Width/ Nozzle: 0.4 mm
Outer Wall: 0.70 mm
Recommended Layer Height: 0.16 mm
Wall Loops: 3
Top Shell Layers: 0
Bottom Surface Pattern: Monotonic Line
Bottom Shell Layers: 5
Speed For Outer Wall: 30 mm/s
Wall Overlap: 50%
Infill: 0%
Click with the right button to “Height Range Modifier” and set it 5 Walls from 0 to 1 mm height. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing! 3D MODEL ASSEMBLY You will need for this project: 5mm Pre Wired LED, Red DC3-5V – Amazon / Aliexpress 22awg Silicone Electrical Wire – Amazon / Aliexpress Soldering Iron Kit – Amazon / Aliexpress USB Mini Humidifier – Amazon / Aliexpress 5V 2A Micro USB Power Supply – Amazon / Aliexpress ASSEMBLY HUMIDIFIER https://youtu.be/-Rtc5Q0A0dc 1 – Solder the wire to the negative on the board (which is indicated on the back side). 2 – Solder the positive wire of the LED onto CI-C2. 3 – Connect the positive and negative of the LED onto the wires soldered to the board. 4 – Place the LED on the support attached to the piece, placing it upside down. 5 – Fit the speaker inside the support (which came with the kit). 6 – Connect the speaker to the board. 7 – Place the board inside the drawer. 8 – Place the button on the main piece and fit the drawer into position. 9 – Fix the speaker’s support onto the printed support. 10 – Fit the support with the speaker onto the main piece, with the speaker facing up. 11 – If the model has any external finishing for the button, this is when you should glue it. 12 – Cut the cotton stick that came with the kit according to the needed height for each model (insert the cotton into the support center, making sure a piece is touching the water tank). 13 – With the water tank properly placed into the center of the base, fill it with water. 14 – Place and twist the upper part so it fits properly into the base. 15 – Connect the 5V power supply to the board and plug it. Press the button once to turn the LED and direct mode, or press it twice to turn the LED and intermittent mode.

 
Vrei să cumperi produsul printat 3D?
 
Mergi la pagina de produs